dokuwiki

Yes, based on the components and quantities you've listed, it appears that you have the necessary parts to mount 16 Trina Vertex S 450W solar modules using the K2 D-Dome 6.10 system. Here's a breakdown:

K2 D-Dome 6.10 System Pre-assembled Base Rail Set 2.48m (2004095): You have 8 sets. The base rails are crucial for supporting the modules. For 16 modules, especially in a back-to-back (east-west) configuration typical of the D-Dome system, 8 sets should suffice.

K2 DomeClamp MC Set 30-50mm End Clamp (16 clamps) and K2 DomeClamp MC Set 30-50mm Middle Clamp (24 clamps): These clamps secure the modules to the rails. The quantities you've provided should cover all the end and middle positions for 16 modules.

K2 Dome 6.10 Peak Module Elevation (16 pieces): These are used to elevate the modules at the peak point in the D-Dome system. Having 16 pieces suggests one for each module, which is appropriate.

K2 Speed Porter Ballast Holder (16 pieces): These hold the ballast that keeps the system stable on the roof. Again, 16 pieces align with one per module.

K2 Dome 6.10 Connector Bonding Set (4 sets): These connect the base rails together. The number of sets you've included should be adequate for your system's layout.

K2 Lightning Protection Clamp Multi Half Part 8mm Set (8 sets): These are important for grounding and lightning protection. With 8 sets, you likely have one for every pair of modules, which is suitable.

K2 TerraGrif K2MI Duo 18 Module Grounding Clip (16 clips): Grounding clips are essential for electrical safety. Having one per module ensures each module is properly grounded.

K2 Cable Manager PA66W Cable Tie (50 ties): These help manage and secure cables. Fifty ties should be more than enough for 16 modules.

K2 Self-Tapping Screw 4.8×20 mm (32 screws): These are used for fastening various components. With 32 screws, you have two per module, which should meet installation requirements.

Given the size of your modules (1762x1134x30 mm), it's important to ensure that the clamps and mounting system are compatible with these dimensions, which the K2 D-Dome 6.10 system and the 30-50mm clamps are designed to accommodate.

Recommendation: While the quantities seem appropriate, I recommend verifying your specific roof layout and module arrangement with K2's planning tools or consulting directly with a K2 Systems representative. This will ensure all components fit your installation's unique requirements and comply with local regulations and standards.